 |
Carbon Fiber Tubes - Roll Wrapped
Manufactured by wrapping unidirectional carbon fiber prepreg tape around a mandrel with the majority of carbon fiber running longitudinally. This type of construction offers a high stiffness to weight ratio tube.
-
Note: Tolerance on ID is +/- .010". Tolerance on OD is +/- .015"
-
Closer OD tolerances are available, please call for quote
CUT OPTIONS
Low Tolerance Cut:
High Tolerance Cut:
Higher Tolerance Cut:
-
Please call 800-811-2009 for quote
|
 |
Carbon Fiber Tubes
Carbon Tubes are the ultimate push rods since they contain 95% unidirectional carbon fiber running longitudinally and are covered with a light glass scrim. This design offers a high stiffness to weight ratio and makes these tubes ideal for 1/4 scale aircraft pushrods, and slope soarer and helicopter tail booms.
CUT OPTIONS
Low Tolerance Cut:
High Tolerance Cut:
Higher Tolerance Cut:
-
Please call 800-811-2009 for quote
|
 |
Carbon Fiber Tubes - Tapered
Manuafactured by wrapping unidirectionalcarbon fiber prepreg tape around a tapered mandrel with the majority of the carbon fiber running longitudinally. The tapered tubes differ from the carbon fiber straight wrapped tubes only in their shape and offers a high stiffness to weight ratio tube.
CUT OPTIONS
Low Tolerance Cut:
High Tolerance Cut:
Higher Tolerance Cut:
-
Please call 800-811-2009 for quote
|
 |
Fiberglass Tubes
Unlike conventional filament winding, ACP's tubes are manufactured by using a unique production process whereby longitudinal fibers are oriented to provide excellent tensile, compressive, and flexural properties. Circumferential windings between longitudinal plys give the tubing exceptional burst, crush, and transverse strength. The tubes can be used for push rods or the outer sleeve for wing joiner tube assemblies. You will note that the inside diameter of the Fiberglass Tubes have been sized to fit snugly over the following carbon rod diameters: .230", 5/16", and 1/2". For example, the .234 ID glass tube and the .230 hollow carbon rod have been used as tube assemblies for removable stabs on gliders and pattem aircraft. Also the TU-03 and TU-04 can be used to form a wing joiner tube assembly, since the O.D. of the TU-03 is .414 and the I.D. of the TU-04 is .417.
CUT OPTIONS
Low Tolerance Cut:
High Tolerance Cut:
Higher Tolerance Cut:
-
Please call 800-811-2009 for quote
|
|
|
